TA410/810 User Manual
You can change the response code on TA410/810 to the one you want before sending
it to the VoIP server. It helps the VoIP server understands better the exact call status,
like busy, no response and others.
Figure 4-11 Response Code
Note: We don’t’ recommend configuing this if you are not familiarwith the code of call
status from the VoIP server.
6) Advanced Settings
Figure 4-12 SIP Advanced Settings
Table 4-9 Description of SIP Advanced Settings
Where to get the caller ID in SIP packet.
Where to get the DID in SIP packet.
It is set when the telecom provider needs.
Usually it is not needed.
Whether to send Remote-Party-ID on SIP header
or not. Default: no.
Allow Guest
Whether to allow anonymous registration
extensionor not. Default: no. It’s
recommendedthat it is disabled for security
reason.
Enable pedantic parameter. Default: no.
If enabled, when TA410/810 rejects “Register”
To Next Page
Loading...
Need help?
General
