TA410/810 User Manual
PNP and DHCP modes work along with MyPBX "NeoGate Provisioning". Firstly,
users need to configure TA410/810 on MyPBX "NeoGate Provisioning" page.
Then TA410/810 will find and get the configuration file from MyPBX during boots
up.
Figure 3-26 MyPBX NeoGate Provisioning
If you use DHCP mode to do auto provision, you should enable DHCP Server on
MyPBX to make it as a DHCP server. (System→Network Preferences→DHCP
Server).
Figure 3-27 Set MyPBX as a DHCP Server
Then select DHCP mode on LAN settings page to make TA410/810 as a DHCP client.
Figure 3-28 Set TA410/810 as a DHCP Client
31/55
To Next Page
Loading...
