TA410/810 User Manual
> Call Duration Settings
Table4-2 Description of FXO Port Call Duration Settings
Single Call Max Duration(min)
Configure the duration of each call, it’s 0 by default,
which means no limit.
Once the value of Billing Unit is changed, the
“Round Up Duration” will be cleared, “Call
Duration” will also change accordingly.
Defines the maximum number of billing unit called
within a month through the trunk
limitation set the value at 0.
The date to clean the duration status each month.
Balance Alarm Settings
When Max. Call Duration(min) is configured a 0 (no
limit), this feature is disabled.
Cofigure the time duration when TA410/810 will
send the alarm message. The value must be less
than “Max Call Duration”.
Choose the port to dial the alarm call.
The number to receive the alarm call.
The prompt played during the alarm call,you can
customize the prompts as your wish.
E-mail
The email address to receive the alarm email.
Note: please make sure SMTP test is successful
in “Email settings” page before configuring this.
> Other Settings
Table4-3 Description of FXO Port Other Settings
Hangup
Detection
Hangup Type
Select which kind of hangup type will be used to
detect the call and hang up.
Enable or disable Busy Detection. It is used for
detecting far end hangup or busy signal.
If Busy Detection is enabled, it is also possible to
specify how many busy tones to wait for before
hanging up. The default is 4, but better results
can be achieved if this setting is set as 6 or 8.
more time for detection,
but lower the probability that a false detection
may occur.
Set the busy detection interval.
If Busy Detection is enabled, you need to specify
To Next Page
Loading...
Need help?
General
