TA410/810 User Manual
1) Configure a IP-> Port route on TA410/810; choose the VoIP trunk in the field
“Call Source”, and choose PSTN trunk in the field “Call Destination”.Enable
Two-stage Dialing on the route.
2) Make a call from your SIP server, dial the SIP account number which is
registered on TA410/810. You will hear a dial tone, then dial the external
number out through PSTN trunk.
Calls from PSTN to SIP
1) Configure a Port->IP route on TA410/TA810, choose PSTN trunk in the field
“Call Source”, and choose the SIP trunk in the filed “Call Destination”.
2) When an incoming call reaches PSTN trunk on TA410/810, you will hear a
dial tone, then dial an extension number of the SIP server.
SPS Mode(Recommended)
Create a Service Provider SIP trunk on TA410/810 to connect to your SIP server. Add
another Service Provider SIP trunk on your SIP server, connecting to TA410/810.
Calls from SIP to PSTN
1) Create one outbound route on your SIP sever, and select the SIP trunk you
have created just now.
2) Configure a IP->Port route on TA410/810, choose the SPS trunk in the field
“Call Source”, and choose PSTN trunk in the field “Call Destination”.
3) Make a call from your SIP Server and the call should match the outbound
route dial rules.
Calls from PSTN to SIP
1) Configure a Port->IP route on TA410/810, choose PSTN trunk in the field
“Call Source”, and choose the SPS trunk in the filed “Call Destinatiom”.
2) Create one inbound route on your SIP server and select the SIP trunk created
just now.
3) When an incoming call reaches PSTN trunk on TA41/810, You will hear a
dial tone, then dial an extension number of the SIP Server, it will be routed to
the destination of the SIP server inbound route.
Note:if you want the call to go directly to the destination number of your SIP
server, you don’t have to create an inbound route on SIP server, instead set a
Hotline number on TA410/810 route.
6/55
To Next Page
Loading...
Need help?
General
