13-1
IM 2558A-01JA
Commands
3
2
1
4
5
6
7
8
9
10
11
12
13
Chapter 13 Commands
13.1 List of Commands
Command Function Page
CALibrate Group
For details on how to change the password and adjust the voltage and current ranges, see the following webpage.
http://www.yokogawa.com/ymi/
COMMunicate Group
:COMMunicate?
Queries all communication settings. 13-3
:COMMunicate:HEADer
Sets or queries whether headers are attached to query responses. 13-3
:COMMunicate:LOCKout
Sets or queries the local lockout state. 13-3
:COMMunicate:REMote
Sets or queries whether the 2558A is in remote or local mode. 13-3
:COMMunicate:VERBose
Sets or queries whether the response to a query is returned fully spelled out
or in its abbreviated form.
13-3
:COMMunicate:WAIT
Waits for a specified extended event to occur. 13-3
:COMMunicate:WAIT?
Creates the response that is returned when a specified extended event
occurs.
13-3
DIVider Group
:DIVider?
Queries all output divider settings. 13-4
:DIVider:DENominator
Sets or queries the denominator of the output divider. 13-4
:DIVider:NUMerator
Sets or queries the numerator of the output divider. 13-4
FREQuency Group
:FREQuency?
Queries all frequency settings. 13-5
:FREQuency:EXTernal:PHASe
Sets or queries the phase angle when EXT2 is selected. 13-5
:FREQuency:FUNCtion
Sets or queries the frequency selection. 13-5
:FREQuency:INTernal:FMETer:MAXi
mum
Sets or queries the maximum scale value of the frequency meter. 13-5
:FREQuency:INTernal:FMETer:MINi
mum
Sets or queries the minimum scale value of the frequency meter. 13-5
:FREQuency:INTernal:VARiable
Sets or queries the variable frequency value. 13-5
:FREQuency:READ?
Queries the current output frequency. 13-5
OUTPut Group
:OUTPut[:STATe]
Sets or queries the output’s on/off state. 13-6
DEViation Group
:DEViation?
Queries all deviation settings. 13-7
:DEViation:VALue
Sets or queries the deviation. 13-7
:DEViation:PRESet
Sets or queries the preset value. 13-7
SOURce Group
:SOURce?
Queries all source settings. 13-8
:SOURce:FUNCtion
Sets or queries the source function (voltage/current). 13-8
:SOURce:LEVel
Sets or queries the main setting. 13-8
:SOURce:RANGe
Sets or queries the voltage or current range. 13-8
:SOURce:READ?
Queries the output value (voltage or current). 13-8
To Next Page
Loading...
Need help?
General