3-3
IM 2558A-01EN
Preparation
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
App
Index
3.2 Installing the Instrument
WARNING
• Do not install the instrument outdoors or in locations subject to rain or water.
• Install the instrument so that you can immediately remove the power cord if an abnormal or
dangerous condition occurs.
CAUTION
If you block the outlet holes on the top and bottom or the inlet holes on the rear of the
instrument, the instrument will become hot and may break down.
French
AVERTISSEMENT
• Ne pas installer l’instrument à l’extérieur ou dans des lieux exposés à la pluie ou à l’eau.
• Installer l’instrument de manière à pourvoir immédiatement le débrancher du secteur en
cas de fonctionnement anormal ou dangereux.
ATTENTION
Si vous bloquez les orifices de sortie sur le dessus ou le dessous de l’équipement ou les
orifices d’entrée à l’arrière de l’équipement, ce dernier s’échauffe et risque de tomber en
panne.
Installation Conditions
Install the instrument in a place that meets the following conditions.
Well-Ventilated Location
Outlet holes are located on the top and bottom of the instrument. There are also inlet holes on the
rear. To prevent internal overheating, allow for enough space around the instrument (see the figure
below), and do not block the inlet and outlet holes.
20 cm or more
When connecting cables, allow for enough space, above and beyond the space shown in the figure
above, to carry out the procedure.
Ambient temperature and humidity
Ambient temperature 5°C to 40°C
Ambient humidity 20% RH to 80% RH (no condensation)
To Next Page
Loading...
Need help?
General