13-10
IM 2558A-01EN
:SWEep?
Function Queries all sweep settings.
Syntax
:SWEep?
:SWEep:DIRection
Function Sweeps up or down or stops sweeping. Queries
the sweep state.
Syntax
:SWEep:DIRection {HOLD|UP|DOWN}
:SWEep:DIRection?
HOLD: Sweeping is stopped.
UP: Sweep up to the maximum scale value
DOWN: Sweep down to the minimum scale value
Example
:SWEEP:DIRECTION UP
:SWEEP:DIRECTION? -> UP
:SWEep:TIMe
Function Sets or queries the sweep time.
Syntax
:SWEep:TIMe <
Time
>
:SWEep:TIMe?
<Time> = 8, 16, 32, 64(S)
Example
:SWEEP:TIME 16S
:SWEEP:TIME? -> 16
13.9 SWEep Group
The commands in this group deal with the sweep settings. The command corresponds to the front panel SWEEP switch.
To Next Page
Loading...
Need help?
General