3-4
IM 2558A-01EN
Note
Condensation may form when the instrument is moved from a low temperature or humidity environment to a
high temperature or humidity environment, or when there is a sudden change in temperature. In such cases,
before you use the instrument, allow it to adjust to the surrounding temperature for at least an hour.
If you transport the instrument in its packing box, to prevent condensation, allow it to adjust to the new
ambient temperature for at least an hour before taking it out of the box.
Installation Position
Desktop
Install the instrument on a stable surface that is level in all directions and that is not slippery.
The supplied rubber stoppers can be attached to the feet at the rear of the instrument to prevent the
instrument from sliding. You can install the instrument in a tilted position using the movable legs.
WARNING
• Do not adjust the movable legs in an unstable condition.
• Do not place the instrument in any position other than those shown in the above figures.
• Do not stack the instruments with the movable legs pulled out.
• Only one instrument can be stacked on top of another. Do not stack multiple instruments
on top of one instrument.
French
AVERTISSEMENT
• Ne pas manipuler les pieds escamotables lorsque l’instrument est instable.
• Ne pas placer l’instrument dans des positions autres celles indiquées ci-dessus.
• Ne pas empiler des instruments lorsque les pieds escamotables sont sortis.
• Seul un instrument peut être empilé sur un autre instrument. Ne pas empiler plusieurs
instruments les uns sur les autres.
A9088ZM
the instrument
Note
If you attach the front rubber leg cap, you will not be able to stack the 2558A.
3.2 Installing the Instrument
To Next Page
Loading...
Need help?
General