3. Cabling
3-48
TI 33Q01J10-01E
To modify the bottom plates, follow these steps.
1. Remove the bottom plate to be modified.
F030505.ai
Bottom plate
Screw
Cabinet
Figure Removing the Bottom Plate
2. Turn the bottom plate upside down so that the bottom faces upwards.
3. Use a wire cutter or another appropriate tool to remove sections of the bottom plate so that
a hole large enough for the cable to pass through is made. Do not cut the sponge pad on the
reverse side of the plate.
4. Cut and remove the area protective padding approximately 20 mm inside the opening made
in the preceding step.
5. Turn the rim of the protective padding (width: 320 mm) inside out. This will protect the cable
from the rough edges of the plate. The sponge pad has an adhesive surface. Peel the paper
from the surface and stick the sponge pad to the plate.
F030506.ai
Cut the
bottom plate
Cut off a
part of the
sponge pad
Turn over the
sponge pad
Bottom plate
Sponge pad
Sponge pad
Sponge pad
Figure Modifying the Bottom Plate
6. Replace the bottom plate.
May 18, 2007-00
To Next Page
Loading...
