3. Cabling
3-47
TI 33Q01J10-01E
Modifying the Cabinet Bottom Plates for Cable Wiring
Cables are passed through the holes in the bottom plates of the cabinet.
The diameters of these holes can be changed to match the diameter of the cables. There are four
bottom plates each at the front and rear of AF
20/ACB21 specifically for signal cable wiring.
There are three bottom plates each at the front and rear of AF
40/ACB41 specifically for signal
cable wiring.
Figure Bottom Plates of AF20/ACB21
May 18, 2007-00
To Next Page
Loading...
