5. Post-installation Inspection and Environmental Preservation
5-1
TI 33J01J10-01EN
5. Post-installation Inspection and
Environmental Preservation
lPost-installation Inspection
Upon the completion of installation of instrumentation, before turning on the power inspect the
condensation.
Table Inspection before Power On
Inspection items (daily inspection/maintenance items)
Environment
No water intrusion from cable ducts.
Air-conditioned
Cabinets and surroundings cleaned
No direct sunlight on equipment
Equipment
No condensation or traces on cards (disconnect cards on the upper, middle, and lower
stands, and left and right sides of the cabinet to check that there is no condensation on the
cards or defects anywhere in the cabinet.)
No dust remaining inside cabinet
It is recommended that you turn on the power in the presence of Yokogawa when turning it on
lPost-installation Environment Preservation
system has been installed:
moisture from the other rooms.
• Seal all cable ducts of equipment and building with putty upon completion of cabling.
and the system. Otherwise condensation may occur.
• Monitor and record ambient temperature and humidity. To maintain the reliability of the
whiles pulling cables, may result in condensation.
Mar. 6, 2015-00
To Next Page
Loading...
Need help?
General
