<3. Converter menu>
3-8
IM 12A01F01-03EN 2nd Edition : Feb. 19, 2019-00
you see the same list on the screen of Load factory default.
NOTE
For Multiple sensor connection
setting after resetting.
If you reset the system while multiple SENCOM SA are being connected to one sensor module,
Sensor Address setting (S) and “SENCOM address (S)” are reset, too. If you re-start multiple
SENCOM SA.
For further information read 4.6.1 of this manual, and 3.1.3 in each manual for Operation of pH/
ORP/SC/ISC and DO.
To Next Page
Loading...
