<4. Setting converter>
4-34
IM 12A01F01-03EN 2nd Edition : Feb. 19, 2019-00
4.8 Logbook
and others. Logbook helps you, for example, to be aware of maintenance due.
Data in Logbook cannot be deleted, once it is stored.
Once you store data, the data are sorted out, being categorized into Converter and sensors.
Alarm name Description
Converter Error on Converter error occurs.
Converter error is cancelled
mA output settings mA output settings are changed
Relay wash setup Contact output Wash setup is changed.
Relay alarm setup Contact output alarm setup is changed.
Relay function setup Contact output function setup is changed.
Relay fail setup Contact output error setup is changed.
Relay simulate setup Contact output simulate setup is changed.
Sensor Error on Sensor error occurs.
Sensor error is cancelled.
Compensation setup Compensation setup is chaged.
Calibration setup Calibration setup is changed.
Impedance setup Impedance setup is changed.
detects errors inside. You can see the error history recorded in the logbook, by setting “Logbook
setting” to “Error On”.
NOTE
SENCOM SA keeps the log to record alarm message, event history such as calibration.
The converter shows the event log only that took place after the corresponding sensor was
connected.
If you need to see logs, which was stored in SENCOM SA before the event took place, you
should use FieldMate.
NOTE
To Next Page
Loading...
