<4. Setting converter>
4-19
IM 12A01F01-03EN 2nd Edition : Feb. 19, 2019-00
4.4.6 Simulate
On: S1/S2/S3: close, S4: open
You can see the simulated contact settings on the measuring mode. If you move from device
output is simulated, an error (Check Function) occurs.
Apart from “Simulate “settings, MODBUS can simulate contact output without changing the
will be cancelled when you turn down power.
l Fail safe
You can set this function to only S4.
When Fail safe function is selected and a fail is detected, the contact turns On (S4: open) and
When Fail safe function is selected and Failure is detected, even if you move the setting to other
l O
No contact output is used.
To Next Page
Loading...
