<4. Setting converter>
4-1
IM 12A01F01-03EN 2nd Edition : Feb. 19, 2019-00
4. Setting Converter
We recommend that you write down parameters on “User Setting Table” we provide and keep it
for future use.
You can download “User Setting Table” from our website.
Home/Main > “Menu” > Converter menu > “Setting”> Converter settings
When you go to Converter settings, mA output is in HOLD and Contact output keeps the status.
This stays on for 3 seconds after you exit the converter setting screen.
Sec. 4.1
Sec. 4.2
Sec. 4.3
Sec. 4.4
Sec. 4.5
Sec. 4.6
Sec. 4.7
Sec. 4.8
Figure 4.1 Converter settings (sample image)
Refer to corresponding sections to change a parameter. If you set wrong parameter, set it back to
Some parameters have symbols on the right side, such as (A). This symbol represents the
the operation if they do not correspond to Model code or application.
Figure 4.2 Parameter with symbols (sample)
To Next Page
Loading...
