<4. Setting converter>
4-24
IM 12A01F01-03EN 2nd Edition : Feb. 19, 2019-00
4.5.4 Others
l Auto Return
screen), when there is no touch operation during the set time interval.
You can select the interval to implement Auto Return among “Disable”, “10 min”, “60 min”. If you
want to disable this function, select “Disable”.
NOTE
NOTE
The default of Auto return is 10 min. If you expect to have a time-consuming operation such as
calibration, “60 min” or “Disable” is recommended. However, if you do not save the data after
changing the setting, auto return is not activated.
l Backlight saver
be turned on.
fail is cancelled.
l MONITOR Display
screen does not come out when a fail happens, Hold is on, or Wash is in progress.
When this setting is “On”, the screen auto-returns to Monitor screen.
l Alarm NE107
When a fail on the converter or sensors is detected, Home or Main screen displays the diagnostic
information.
Main alarm
, , , or ,
Sensor alarm
, , , or
When “Alarm NE107”* is “On”, (“On” as factory default), the icons in accordance with NAMUR
NE107*, one of
, , , lights on upon detection of each alarm.
If a sensor alarm was detected, one of
, , , lights on.
(Fault) or (Warning) blinks.
Read 2.4 Alarms.
To Next Page
Loading...
