<4. Setting converter>
4-9
IM 12A01F01-03EN 2nd Edition : Feb. 19, 2019-00
4.3 mA output settings
n mA1/mA2/mA3 (Ad)/mA4 (Ad)
Set each mA output. “Output” is default.
Output: mA output according to each setting
When mA Output/Input is “-A2”, mA output of only mA1 and mA2 are settable. When mA Output/
Input is “-A4”, mA output of mA1, mA2, mA3(Ad), mA4(Ad) are settable. When mA Output/Input
NOTE
Set “Output” at mA1 for HART.
4.3.1 Output
l Process parameter slot
Select a sensor from “Sensor 1-1”, “Sensor 1-2”, “Sensor 1-3”, “Sensor 1-4”, “Sensor 2-1”,
“Sensor 2-2, “Sensor 2-3”, “Sensor 2-4”, “Converter” to output process parameter. If you
set converter parameter (ex. mA input, script, arithmetic by multiple sensors) to the process
parameter, select “Converter.”
NOTE
Latest revision does not support script, or arithmetic by multiple sensors.
Sensors must be assigned addresses for MODBUS network in advance. Read 4.6.1.
To Next Page
Loading...
