<3. Converter menu>
3-7
IM 12A01F01-03EN 2nd Edition : Feb. 19, 2019-00
3.4 Reset
If you need to reset to factory default, follow this procedure. In a usual operation, you don’t need
reset.
CAUTION
Once you reset the converter, every data of, language, password, device setting is cleared and
reset to default, excluding date/time.
To connect SENCOM SA, display the measurement or establish communication of HART or mA
output, you need to set up network system for SENCOM SA and assign each sensor-module
address of HMI.
l How to reset parameters
1. On Home/Main screen, tap to go to Converter menu.
2. Press
“Reset”.
Select the appropriate connection to suit your sensors from the list below.
List of Load factory defaults
PH SC ISC DO
PH+PH SC+PH ISC+PH DO+PH
PH+SC SC+SC ISC+SC DO+SC
PH+ISC SC+ISC ISC+ISC DO+ISC
PH+DO SC+DO ISC+DO DO+DO
“Execute”.
(1) (2)
(3) (4)
Figure 3.7 How to reset parameters
To Next Page
Loading...
