<4. Setting converter>
4-3
IM 12A01F01-03EN 2nd Edition : Feb. 19, 2019-00
If the setting has problem, such as out-of-range setting, tapping locates the item with problem
being highlighted in yellow. Even after you move to upper layer by tapping “<” key, you will see
the corresponding item in yellow, which makes you easy to go back to the parameter concerned.
Check the problem and edit the value again.
変更
Figure 4.4 Chart ow at Converter settings-wrong value input
according to the combination or application you need. See Table 4.3.
Find default value or setting range in “User setting table”.
change parameters without any error.
You can export the data to SD card memory, too. (see 5.1.8 Export all logbook )
safe. For information on password setting read 5.4 Password
To Next Page
Loading...
