<4. Setting converter>
4-13
IM 12A01F01-03EN 2nd Edition : Feb. 19, 2019-00
l Setpoint, Direction, Hysteresis, Delay time, Expiry, time
Setpoint; This decides the value to activate contact output (S1/S2/S3: close, S4: open)
when an alarm occurs.
Direction: This selects “High” or “Low” to report the value is outside of the limit.
beyond the Setpoint in Direction.
Setpoint
Hys.
SC
off on off
Delay time Delay time
t (sec)
Figure 4.5 Alarm contact
l Expiry time
fails. To cancel the alarm, go to the Error code and cancel the error. If you set Expiry time to 0.0
second, it turns invalid.
Figure 4.6 Error code example when a contact output exceeds the Expiry time
To Next Page
Loading...
