<4. Setting converter>
4-15
IM 12A01F01-03EN 2nd Edition : Feb. 19, 2019-00
l Wash status
You can stop the current wash cycle in Wash status.
Go to Main screen >
> Wash status, select a contact output to stop Wash and tap “
Figure 4.8 Wash cycle display on Main screen (left) and wash status (right)
Wash cycle consists of (Tw): Wash time and (T
R
): Recovery time. Once you tap “Wash”, Wash
ends. (Figure 4.9) Recovery time is for a sensor to return to the regular measuring status.
Measuring WASH
Recovery
End of Wash time
Tap WASH
End of T
R
Recovery time
Tap WASH
WASH
HOLD
WASH
HOLD
End of Interval
n Interval time, Wash time, Recovery time
Set each value in the following unit.
Interval time: hours
Wash time/measuring time (when continuous washing, measuring time): minutes
Recovery time: minutes
NOTE
Set each value to follow the relationship:
Interval time > Wash time + Recovery time
The value of Interval time is greater than the sum of Wash time and Recovery time.
If you set Interval time to 0.0 seconds, Wash does not start automatically. Once you change the
setting of Wash, Interval time recounts immediately after the setting change. However, if the
Wash contact output is in Hold, Wash does not start either automatically or manually.
To Next Page
Loading...
