YOKOGAWA WT210 User Manual

13-15
IM 760401-01E
Communication Commands 1 (System of Commands before the IEEE 488.2-1987 Standard)
13
13.1 Commands
YC/YC? Sets the display channel while the
comparator function is ON/inquires
about the current setting.
Syntax YC m <terminator>
“m” indicates the channel number
for display
• in case of single mode
m= 1: Displays limit and
measurement value on
display 1
2: Displays limit and
measurement value on
display 2
3: Displays limit and
measurement value on
display 3
4: Displays limit and
measurement value on
display 4
• in case of dual mode
m=1,2:Displays limit and
measurement value on
display 1 and 2
respectively
m=3,4:Displays limit and
measurement value on
display 3 and 4
respectively
Query YC? <terminator>
Example YC1
Description Parameter error 12 will occur if “m” is set to an
illegal value.
YM/YM? Sets the mode of the comparator
function/inquires about the current
setting.
Syntax YM m <terminator>
“m” indicates the display mode
m= 0: Single mode
1: Dual mode
Query YM? <terminator>
Example YM0
Description Parameter error 12 will occur if “m” is set to an
illegal value.
YO/YO? Sets the comparator function ON/OFF or
inquires about the current setting.
Syntax YO m <terminator>
“m” indicates whether the
comparator function is ON/OFF
m= 0: OFF
1: ON
Query YO? <terminator>
Example YO1
Description Parameter error 12 will occur if “m” is set to an
illegal value.
ZC Executes zero-level compensation.
Syntax ZC <terminator>
Description • Zero-level compensation is not allowed while
integration is in progress; execution error 13
will occur.
• While recalling is in progress, execution error
19 will occur.

YOKOGAWA WT210 Specifications

General

Brand	YOKOGAWA
Model	WT210
Category	Measuring Instruments
Language	English