14-14 IM 760401-01E
Command Description Page
STORe Group
:STORe? Queries all settings related to storing data. 14-41
:STORe:INTerval Sets/queries the interval for storing data. 14-41
:STORe:PANel Saves the setup parameters to a file. 14-41
:STORe[:STATe] Sets/queries the store function ON/OFF. 14-41
Common Command Group
*CAL?
Executes zero-level compensation and queries the results.
14-42
*CLS
Clears the standard event register, extended event register and error queue.
14-42
*ESE Sets/queries the value of the standard event enable register. 14-42
*ESR? Sets/queries the value of the standard event register and clears it. 14-42
*IDN? Queries the instrument model. 14-43
*OPC This command is not supported by this instrument. 14-43
*OPC? This command is not supported by this instrument, and is always “1”. 14-43
*OPT? Queries installed options. 14-43
*PSC Sets/queries whether or not to clear some registers at power ON. 14-43
*RST Initializes the setup parameters. 14-43
*SRE Sets/queries the value of the service request enable register. 14-43
*STB? Queries the value of the status byte register. 14-43
*TRG Executes the same operation as the TRIG(SHIFT+HOLD) key. 14-43
*TST? Executes a self-test and queries the results. 14-43
*WAI This command is not supported by this instrument. 14-43
14.3 Commands
To Next Page
Loading...
Need help?
General
