YOKOGAWA WT5000 Features Guide

Index-3
IM WT5000-01EN
Index
O
Page
offset value (motor evaluation) ............................................. 5-8
optimization ........................................................................ 16-3
Optimize Count ................................................................... 16-3
other domain name............................................................. 18-2
P
Page
Pc Formula ......................................................................... 8-10
Peak Over Jump ................................................................... 4-5
Phase .................................................................................. 8-11
phase difference .................................................................. 8-11
PLL source ........................................................................... 7-1
PLL Source ........................................................................... 7-1
Pole .................................................................................... 5-14
power coefficient .................................................................. 3-11
power range.......................................................................... 3-9
p-p compression .................................................................. 11-5
Preference .......................................................................... 19-5
pulse count ......................................................................... 5-13
pulse input range ................................................................. 5-11
Pulse N ............................................................................... 5-13
pulse noise filter.................................................................. 5-10
Pulse Noise Filter ............................................................... 5-10
Pulse Range Lower ............................................................. 5-11
Pulse Range Upper ............................................................. 5-11
pulse rating .......................................................................... 5-11
Q
Page
q Mode............................................................................... 14-11
R
Page
range (motor evaluation) ...................................................... 5-7
range Σ link ........................................................................... 4-3
Range Σ Link ........................................................................ 4-3
rasters.................................................................................. 11-5
Rated Freq Lower ................................................................ 5-11
Rated Freq Upper ................................................................ 5-11
Rated Lower ........................................................................ 5-11
rated time for integrated D/A output.................................... 6-15
Raterd Upper ....................................................................... 5-11
real-time continuous integration mode ............................... 14-8
real-time normal integration mode ...................................... 14-7
recording, start.................................................................... 16-9
remote control..................................................................... 19-7
Remote Control .................................................................. 19-7
remote mode, releasing ...................................................... 19-8
Reset Items ........................................................................ 10-7
Reset Pattern...................................................................... 10-7
rising ..................................................................................... 6-8
rounding to zero.................................................................. 19-5
Rounding to Zero ................................................................ 19-5
S
Page
save conditions .......................................................... 16-7, 17-6
Save Setup ........................................................................... 2-3
Scale Mode........................................................................ 11-13
scale value........................................................................... 11-7
Scale Value .......................................................................... 11-7
scaling ................................................................................ 3-10
Scaling ................................................................ 3-10, 5-5, 11-9
scaling (motor evaluation) .................................................... 5-5
scheduled storage time ...................................................... 16-4
scheduled time ................................................................... 14-9
screen image colors ........................................................... 17-5
screen image data format ................................................... 17-5
Selected Items ........................................................... 16-5, 17-4
self-test ............................................................................... 19-9
Selftest................................................................................ 19-9
Sense Type ........................................................................... 5-6
Sensor Ratio ......................................................................... 3-8
separator ............................................................................ 19-5
setup data loading ................................................................ 2-4
setup data, saving ................................................................ 2-3
S Formula ............................................................................. 8-8
SF Scaling ........................................................................... 3-11
SINGLE .............................................................................. 13-1
single measurement ........................................................... 13-1
slave ................................................................................... 8-12
slip ...................................................................................... 5-14
Slope .................................................................................... 6-8
slope (motor evaluation) ....................................................... 5-8
SNTP .................................................................................. 18-5
Source ................................................................................ 5-14
S,Q Formula ......................................................................... 8-9
standard integration mode .................................................. 14-6
Star>Delta ............................................................................ 6-4
starting harmonic order...................................................... 11-13
Start Order ......................................................................... 11-13
storage................................................................................ 16-1
storage conditions .............................................................. 16-1
storage control .................................................................... 16-2
storage count ...................................................................... 16-3
storage interval ................................................................... 16-4
storage mode...................................................................... 16-2
storage, resetting .............................................................. 16-10
storage, stopping ................................................................ 16-9
Store At Start ...................................................................... 16-4
Store Count ........................................................................ 16-3
stored items ........................................................................ 16-5
Store Mode ......................................................................... 16-2
synchronous measurement ................................................ 8-12
Sync Measure..................................................................... 8-12
Sync Source ....................................................................... 5-10
sync source (motor evaluation) .......................................... 5-10
sync speed ......................................................................... 5-14
Sync Speed ........................................................................ 5-14
System Config .................................................................... 19-3
system configuration........................................................... 19-3
System Overview................................................................ 19-2
T
Page
TCP/IP ................................................................................ 18-2
test item .............................................................................. 19-9
Test Item ............................................................................. 19-9
Thd Formula ......................................................................... 7-3
time axis ................................................................... 11-4, 11-10
Time Difference From GMT ................................................ 19-3
Time/div .................................................................... 11-4, 11-10
total efficiency ..................................................................... 5-16
trademarks................................................................................ ii
Trend ................................................................................... 11-8
trend display ........................................................................ 11-8
trend number ....................................................................... 11-9
trend, restarting ................................................................. 11-10
trend scale ........................................................................... 11-9
trigger ................................................................................... 6-8
Trigger Event ...................................................................... 16-4
trigger level ........................................................................... 6-9
trigger mode ......................................................................... 6-8
trigger point........................................................................... 6-9
Trigger Settings .................................................................... 6-8
trigger slope .......................................................................... 6-8
trigger source........................................................................ 6-8

YOKOGAWA WT5000 Specifications

General

Frequency Range	DC, 0.1 Hz to 1 MHz
Number of Channels	Up to 7
Interfaces	USB, Ethernet, GP-IB, RS232
Sampling Rate	10 MS/s
Harmonic Analysis	Up to the 500th order
Weight	Approximately 15 kg
Display	10.1-inch WXGA (1280 x 800) TFT LCD