<7. Startup>
7-1
IM 11M12G01-02EN 1sh Edition : Mar. 25, 2021-00
7. Startup
System tuning by the HART communicator, refer to IM11M12A01-51E “ HART Communication
Protocol ”.
7.1 Startup Procedure
The startup procedure is as follows:
CAUTION
If you connect Model ZO21DW detectors, then you need to change the detector parameters.
Check valve type setting
Check piping & wiring
Check settings
If connecting ZO21DW
Briefly power on
Set detector to ZO21DW
(front panel)
Power OFF
If detector is ZR22
Permanent power wiring
Start set parameters
Figure 7.1 Startup Procedure
To Next Page
Loading...
Need help?
General
