<8. Detailed Data Setting>
8-15
IM 11M12G01-02EN 1sh Edition : Mar. 25, 2021-00
8.5.3 Default Values
When the analyzer is delivered, or if data are initialized, alarm and other setting defaults are as
shown in Table 8.13.
Table 8.13 Output Contact Default Settings
Item to be selected Contact
output 1
Contact
output 2
Contact
output 3
Contact
output 4
Alarm
settings
(HH) high-high alarm
(H) high alarm ON
(L) low alarm ON
(LL) low-low alarm
Calibration correction alarm
Calibration stability alarm
Upper and lower temp. alarm
Upper and lower press. alarm
Simple cell resistance alarm
Fault ON
Other
settings
Warmup ON
Switching output range
Calibration ON
Maintenance ON
Blow back
Cal. gas pressure drop
Process upset
Cal. blowback simple cell resist.
Contact state during operation Open Closed Closed
Closed
Note: Blank boxes in the above table indicate that the default is “disabled.”
To Next Page
Loading...
Need help?
General
