The Other YN-622C User Guide v.4.09
11/12/2014 Page 6 of 64
Part II – 622C continued
Transceiver Features.................31-33
Saving the Settings
AF-Assist Beam
Autofocus Assist
Setting Confirmation
Sleep Wakeup
Channel Indicators
Transceiver Status Indicator
Power Up / Initialise
Standby / Remote – Mix
Communicating
Low battery indicator
Group Indicators
Receiver Group
Test Firing Group
Camera Firing Group
Part III – C-TX Controller.......35-44
C-TX Control Modes .......................36
Remote Control
Local Control
Base Trigger
Fuji Cameras
C-TX Interface.............................37-38
The Buttons
Restore Factory Defaults
The LCD Display
Indicators
Status indicator
Battery Charge indicator
Access and Visibility
Exposure Modes ........................39-41
Selecting a Group’s settings
Set Exposure mode
E-TTL Mode
Set Group FEC
Set Global FEC
Using Flash Exposure Lock
Enable Ratio and Back Lighting
Enable FEB
Manual Mode
Set Group Manual Output
Multi Mode
Enable Multi
Shutter Sync Modes .......................41
Set Sync Mode
Camera Features.............................42
Camera External Flash Menus
Enable Remote Shutter Release
Flash Features.................................42
Set Group Zoom
C-TX Controller Features ..........43-46
Update C-TX Firmware
Set Channel
Test communications and flashes
Set Super Sync Timing
Using Super Sync
Enable AF-Assist Beam
Enable use on non-Canon cameras
Enable Remote Manual pre-2007
Enable Free Mask cutout
To Next Page
Loading...
Need help?
General
