JOHNSON CONTROLS
145
FORM 160.78-O2
ISSUE DATE: 5/22/2017
4
SECTION 4 - PRINTERS
A printer can be connected to the control center’s
Microboard to print the following reports. The screen
from which each report can be generated is listed in
parenthesis.
• Status - Present system parameters (Printer,
Home)
• Setpoints - Present programmed values of all set-
points (Printer, Setpoints)
• Schedule - Present value of programmed daily
schedule (Printer, Schedule)
• Sales Order - Information on Sales Order Screen
(Printer, Sales Order)
• History - System parameters at the time of the last
normal stop, last fault while running and last 10
faults, whether running or not (Printer, History)
• Cycling or Safety Shutdown Initiated Print -
Snapshot of all system parameters at instant of
shutdown. Automatically occurs if printer is con-
nected at time of shutdown.
• Trend - Prints a snapshot of the existing trend
screen data or prints new data collected after the
trend print key is pressed.
The printer can be permanently connected to the con-
trol center or connected as required to produce a report.
If permanently connected, a DATA LOGGING fea-
ture can produce a Status report automatically, begin-
ning at an Operator selected start time and occurring at
an Operator selected interval thereafter.
The following figures are examples of the different
print reports. Solid State Starter application print re-
ports shown.
• Status, refer to Figure 57 on Page 150
• Setpoints, refer to Figure 58 on Page 152
• Schedule, refer to Figure 59 on Page 154
• Sales Order, refer to Figure 60 on Page 154
• History, refer to Figure 61 on Page 155
• Security Log, refer to Figure 62 on Page 157
• Trend, refer to Figure 63 on Page 157
• Custom Screen, refer to Figure 64 on Page 157
PRINTERS
The following Printers can be used. Printers must be
equipped with an RS‑232 Serial interface.
• Okidata –
Models: 182,182 turbo, 184 turbo
Dimensions: 14 in. wide x 10.5 in. deep
Paper: 8.5 in. wide
Type: Dot matrix impact
Purchase: 800-OKIDATA
• Weigh‑Tronix –
Models: 2600, 1220
Dimensions: 2.3 in. wide x 2.8 in. deep
Paper: 2.25 in. wide
Type: Dot matrix impact
Purchase: USA 800-982-6622
International 707-527-5555
• Seiko –
Printer: DPU414-30B
Dimensions: 6.3 in. wide x 6.7 in. deep
Paper: 4.4 in. wide
Type: Thermal
Power Supply: PW4007I (required)
Battery Pak (Ni-Mh): BP4005
Thermal paper: SS112-025A
Purchase: Jaco Electronics (formally Reptron
acquired by Jaco)
13710 Reptron Blvd
Tampa, Florida 33626
Phone: 800-800-5441
www.jacoelectronics.com
Purchase Contact: Katy Buelow
kbuelow@jacoelect.com
To Next Page
Loading...
