York OPTIVIEW - Security Log Details Screen

JOHNSON CONTROLS
97
SECTION 2 - OPTIVIEW CONTROL CENTER INTRODUCTION
FORM 160.78-O2
ISSUE DATE: 5/22/2017
2
OVERVIEW
This screen allows the user to view the details of a
logged setpoint change, selected from the list on the
Security Log Screen. The date and time the setpoint
was changed, the new and old setpoint value and ac-
cess level and user ID used to make the change are
displayed. The data on this screen can be printed.
The following elds require login access
level of SERVICE. Service technicians re-
fer to YORK YMC
2
Service Manual (Form
160.78-M2) for operation instructions
and explanations of all programmable
setpoints, zone parameters and displayed
values.
DISPLAY ONLY
Description
Displays the setpoint/category that was changed.
Time
Displays the time the setpoint was changed.
Date
Displays the date the setpoint was changed.
Access Level
Displays the Login Access Level used to make the
setpoint change.
User ID
Displays the login User ID used to make the setpoint
change.
Old Value
Displays the previous setpoint value.
New Value
Displays the value entered at the time of the setpoint
change.
PROGRAMMABLE
Print
Generates a report of change parameters displayed on
this screen.
SECURITY LOG DETAILS SCREEN
LD14866
FIGURE 43 - SECURITY LOG DETAILS SCREEN