JOHNSON CONTROLS
148
FORM 160.78-O2
ISSUE DATE: 5/22/2017
SECTION 4 - PRINTERS
PRINTER SETUP
The selected printer must be configured as follows. Re-
fer to manual provided by Printer manufacturer with
respective Printer.
OKIDATA 182, 182 turbo, 184 turbo Printer
CONTROL BOARD Switch settings:
SW1 - on Unslashed 0
2 - off Unslashed 0
3 - off Unslashed 0
4 - off Form Length 11 in.
5 - on Form Length 11 in.
6 - off Auto Line Feed off
7 - on 8 bit data
8 - off Enable front panel
If equipped with a SUPER SPEED serial Board:
SW1-1 - on Odd or even parity
1-2 - on No parity
1-3 - on 8 bit data
1-4 - on Protocol ready/busy
1-5 - on Test select
1-6 - on Print mode
1-7 - off SDD(-) pin 11
1-8 - on SDD(-) pin 11
2-1 - on 1200 Baud*
2-2 - on 1200 Baud*
2-3 - off 1200 Baud*
2-4 - off DSR active
2-5 - on Buffer threshold 32 bytes
2-6 - on Busy signal 200ms
2-7 - on DTR space after power on
2-8 - Not Used
If equipped with HIGH SPEED serial board:
SW1 - off (-) Low when busy
2 - off 1200 Baud*
3 - off 1200 Baud*
4 - on 1200 Baud*
5 - Not Used
6 - off no parity
7 - off Pin 20 and pin 11 act as busy line
WEIGH-TRONIX Printer
IMP-24 Model 2600
SW1 - off 1200 Baud*
2 - on 1200 Baud*
Model 1220
- Configure Menu
Baud= 1200
Data Bits = 8
Stop Bits = 1
Hshake = Busy-Line
Cols = 32
Invert = No
Font = 5 x 8
Mag = None
- Custom Menu
Auto Seq = No
Zero = 0
Pound sign = #
_(Underscore)
Busy invert = no
Online/offline = yes
Ext Ch Set = no
Print ready = yes
Set Clock = Not Used
Reset Seq = Not Used
To Next Page
Loading...
