JOHNSON CONTROLS
84
FORM 160.78-O2
ISSUE DATE: 5/22/2017
SECTION 2 - OPTIVIEW CONTROL CENTER INTRODUCTION
COM 2 Setup
COM2 button is shown only in TESTOP or ADMIN
access levels. COM2 serial port is used for VSD com-
munications.
COM 2 Baud Rate
Define the baud rate at which the panel shall communi-
cate through the modem port.
COM 2 Data Bit(s)
Define the number of data bits with which the panel
shall communicate to the modem port.
COM 2 Parity Bit(s)
Define the number of parity bits with which the panel
shall communicate through the modem port.
COM 2 Stop Bit(s)
Define the number of stop bits with which the panel
shall communicate through the modem port.
GPIC Report
Access Level Required: ADMIN
Allows view of GPIC objects.
NAVIGATION
Home
Causes an instant return to the Home Screen.
Setup
Return to the Setup Screen.
To Next Page
Loading...
