JOHNSON CONTROLS
160
FORM 160.67-O1
ISSUE DATE: 4/1/2015
SECTION 3 - PRINTERS
FIGURE 58 – SAMPLE PRINTOUT (HISTORY) (CONT’D)
Oil Cooler Solenoid = On
Gland Solenoid = On
Nozzle #1 Solenoid = Off
Nozzle #2 Solenoid = Off
Steam Ring Drain Solenoid = Off
Condensate Drain Tank High Level Switch = On
Turbine Oil / Bearings
-------------------------------------------------------
Oil Temperature = 110.7 ~F
Oil Pressure = 18.0 Psig
Governor End Bearing Temperature = 170.1 ~F
Shaft End Bearing Temperature = 150.2 ~F
Aux Oil Pump Run Output = Off
Aux Oil Pump Contact = Open
Aux Oil Pump Manual Mode = Disabled
Hotwell Level
-------------------------------------------------------
HLSP1 - Hotwell Condensate Level = 50.0 %
Condensate Level = 50.1 %
Hotwell Level Control Output Signal = 49.9 %
Pump #1 Run Output = On
Pump #1 Aux Contact = Closed
Pump #2 Run Output = Off
Pump #2 Aux Contact = Open
Low Level Switch = Closed
High Level Switch = Closed
Hotwell Level Control Auto/Manual Mode = Auto
Vacuum System
-------------------------------------------------------
Pump #1 Run Output = On
Pump #1 Aux Contact = Closed
Pump #1 Sealing Water Solenoid = On
Pump #1 Sealing Water Flow Switch = Closed
Pump #2 Run Output = Off
Pump #2 Aux Contact = Open
Pump #2 Sealing Water Solenoid = Off
Pump #2 Sealing Water Flow Switch = Open
Ejector Actuator = Off
Flow Sensor
-------------------------------------------------------
Evaporator Flow = 2616 Gal/Min
Condenser Flow = 4512 Gal/Min
Steam Flow = 14448 Lb/Hr
To Next Page
Loading...
