JOHNSON CONTROLS
150
FORM 160.67-O1
ISSUE DATE: 4/1/2015
SECTION 3 - PRINTERS
PRINTERS
A printer can be connected to the Control Center’s
Microboard to print the following reports. The screen
from which each report can be generated is listed in
parenthesis.
• Status - Present system parameters (Printer,
Home)
• Setpoints - Present programmed values of all set-
points (Printer, Setpoints)
• Sales Order - Information on Sales Order Screen
(Printer, Sales Order)
• History - System parameters at the time of the last
normal stop, last fault while running and last 10
faults, whether running or not (Printer, History)
• Cycling or Safety shutdown initiated Print -
Snapshot of all system parameters at instant of
shutdown. Automatically occurs if printer is con-
nected at time of shutdown.
• Trend - Prints a snapshot of the existing trend
screen data or prints new data collected after the
trend print key is pressed.
The printer can be permanently connected to the Con-
trol Center or connected as required to produce a report.
If permanently connected, a DATA LOGGING feature
can produce a Status report automatically, beginning
at an Operator selected start time and occurring at an
Operator selected interval thereafter.
The following figures are examples of the different
print reports. Solid State Starter application print re-
ports shown. Electro-Mechanical starter and Variable
Speed Drive reports are similar but print parameters
applicable to those devices may differ.
• Figure 55 - Status
• Figure 56 - Setpoints
• Figure 57 - Sales Order
• Figure 58 - History
• Figure 59 - Security Log
• Figure 60 - Trend
• Figure 61 - Custom Screen
The following Printers can be used. Printers must be
equipped with an RS-232 Serial interface.
• Okidata –
Models: 182,182 turbo, 184 turbo
Dimensions: 14 in. wide x 10.5 in. deep
Paper: 8.5 in. wide
Type: Dot matrix impact
Purchase: 800-OKIDATA
• Weigh-Tronix –
Models: 2600, 1220
Dimensions: 2.3 in. wide x 2.8 in. deep
Paper: 2.25 in. wide
Type: Dot matrix impact
Purchase: USA 800-982-6622
International 707-527-5555
• Seiko –
Model: DPU414-30B (Power supply PW4007-U
I required)
Dimensions: 6.3 in. wide x 6.7 in. deep
Paper: 4.4 in. wide
Type: Thermal
Purchase: Reptron Electronics Phone:800-800-5441
ext 4686 Fax: 813-891-4056Attention Nancy Ar-
thur, Account Manager narthur@reptron.com
The Control Center provides the required formatting
control codes for the printers above when the printer
is selected on the PRINTER Screen in the instructions
below. These codes are transmitted through the serial
interface to the printer to provide a proper print format.
Different printers require different formatting control
codes. Other printers might provide proper operation
when connected to the Control Center. However, the
print format may not be correct or as desired. Proceed
with caution and use the following guidelines if an un-
listed printer is selected:
1. All must be capable of RS-232 Serial communica-
tions.
2. Primary differences between printers involve the
formatting control codes required by the printer.
These codes are sent from the Control Center to
To Next Page
Loading...
