York YST - Comms Screen; Figure 31 - Comms Screen

JOHNSON CONTROLS
84
FORM 160.67-O1
ISSUE DATE: 4/1/2015
SECTION 2 - OPTIVIEW CONTROL CENTER INTRODUCTION
COMMS SCREEN
00470VIP
FIGURE 31 - COMMS SCREEN
NOTE: OptiView
™
Control Center Screens shown may NOT represent the exact screens according to the software version utilized.
OVERVIEW
This screen allows definition of the necessary com-
munications parameters. Refer to PRINTER Section
of this book for details of the Printer connections and
setup. Presently, there are no COM 2 communications
features available.
DISPLAY ONLY
None
PROGRAMMABLE
Chiller ID
Access Level Required: OPERATOR
Define the numeric chiller ID when used within an ISN
network of chillers. This ID number is also printed at
the top of reports obtained with a local printer.
Printer Setup and COM 2 Setup
Access Level Required: OPERATOR
Pressing either key places a green selection box around
thefirstchangeableparameter.Usethe▲and▼keys
to place the selection box around the desired param-
eter to be changed. With the selection box around the
desired parameter, press the ENTER ‘’ key. A dialog
box is displayed permitting data entry.
Printer Baud Rate
Define the baud rate at which the panel shall commu-
nicate to the printer.
Printer Data Bit(s)
Define the number of data bits with which the panel
shall communicate to the printer.
Printer Parity Bit(s)
Define the number of parity bits with which the panel
shall communicate to the printer.
Printer Stop Bit(s)
Define the number of stop bits with which the panel
shall communicate to the printer.
COM 2 Baud Rate
Define the baud rate at which the panel shall communi-
cate through the modem port.
COM 2 Data Bit(s)
Define the number of data bits with which the panel
shall communicate to the modem port.
COM 2 Parity Bit(s)
Define the number of parity bits with which the panel
shall communicate through the modem port.