Zebra 105SL Plus User Manual

Printer Configuration and Adjustment
Changing Printer Settings
90
P1056468-002 7/3/13
Non-Resettable
Counter
The non-resettable counter gives the total length of media that the printer has printed.
You can use firmware commands to change the unit of measure for this counter.
Related ZPL command(s):
^MA (for changing unit of measure)
SGD command used:
none
Control panel menu item: NONRESET CNTR on page 24
Printer web page:
none
User-Controlled
Counters
Two user-controlled counters give the total length of media that the printer has printed
since the last time the counter was reset. You can use firmware commands to change the
unit of measure and reset the counters.
Related ZPL command(s):
^MA (for changing unit of measure)
~RO (for resetting counters)
SGD command used:
odometer.media_marker_count1
odometer.media_marker_count2
Control panel menu item: RESET CNTR1 on page 24
RESET CNTR2 on page 24
Printer web page:
none
Print Counter
Readings
Prints a label that lists the odometer readings for the following:
• the non-resettable counter
• the two user-controlled counters
• the Early Warning for Maintenance counters, which indicate when the printhead
was last cleaned and the printhead life (If the Early Warning for Maintenance
feature is disabled, the counters related to it do not print.)
Related ZPL command(s):
~HQ
SGD command used:
none
Control panel menu item:
PRINT METERS on page 24
Printer web page:
none
Table 8 • Maintenance and Diagnostic Tools (Continued)

Zebra 105SL Plus Specifications

General

Brand	Zebra
Model	105SL Plus
Category	Printer
Language	English