Zebra ET51 - Connecting a USB Scanner; Connecting Using Simple Serial Interface; Connecting Using HID Mode

115
2. Replace the battery.
3. After the scanner reboots, scan the barcode below to place the scanner in HID mode.
Figure 81 Bluetooth HID Classic Barcode
4. On the device, swipe down from the Status bar to open the Quick Access panel and then touch .
5. Touch Bluetooth.
6. Touch Pair new device. The device begins searching for discoverable Bluetooth devices in the area and
displays them under Available devices.
7. Scroll through the list and select XXXXX xxxxxx, where XXXXX is the scanner and xxxxxx is the serial
number.
The device connects to the scanner, the scanner beeps once and Connected appears below the device
name. The Bluetooth device is added to the Paired devices list and a trusted (“paired”) connection is
established.
Connecting a USB Scanner
To connect a DS3608 USB scanner, use one of the following methods:
• Simple Serial Interface (SSI) mode
• Human Interface Device (HID) mode.
Connecting Using Simple Serial Interface
To connect a USB scanner using SSI mode:
1. Connect the scanner cable USB connector to the USB port of the device (using a third-party USC-A to
USB-C adapter) or to a vehicle cradle. The scanner beeps.
2. Ensure that the scanner is in SSI mode. Refer to the Refer to the DS36X8 Product Reference Guide and
scan the SSI Over USB CDC barcode.
Connecting Using HID Mode
To connect a USB scanner using HID mode:
1. Connect the scanner cable USB connector to the USB port of the device (using a third-party USC-A to
USB-C adapter) or to a vehicle cradle. The scanner beeps.
2. Ensure that the scanner is in HID mode. Refer to the Refer to the DS36X8 Product Reference Guide and
scan the HID Keyboard barcode or perform a factory reset.