Zebra ET51 - Advanced Wi-Fi Settings

Wireless
88
3. Slide the Wi-Fi switch to the On position.
4. In the network dialog box, select and touch a network.
5. Touch Advanced options.
6. Touch IP settings and select Static.
Figure 54 Static IP Settings
7. In the IP address text box, enter an IP address for the device.
8. If required, in the Gateway text box, enter a gateway address for the device.
9. If required, in the Network prefix length text box, enter the prefix length.
10.If required, in the DNS 1 text box, enter a Domain Name System (DNS) address.
11.If required, in the DNS 2 text box, enter a DNS address.
12.Touch Connect.
13.Touch .
Advanced Wi-Fi Settings
NOTE: Advanced Wi-Fi settings are for the device, not for a specific wireless network.
Use the Advanced settings to configure additional Wi-Fi settings. To view the advanced settings, scroll to the
bottom of the Wi-Fi screen and select Wi-Fi preferences > Advanced.
• Install Certificates – Touch to install certificates.
• Wi-Fi Direct - Displays a list of devices available for a direct Wi-Fi connection.
• WPS Push Button - Touch to connect to a network using Wi-Fi Protected Setup (WPS) push button
method.