Cleaning and Maintenance
Cleaning
14
980618-001 A Thermal Transfer G-Series
TM
Service Manual 8/27/08
3. You may clean the moveable blade if there is visible contaminates on the top of the blade.
Use the cutter blade’s actuator screw on the lower right side of the cutter body to move the
blade up and down. Raise and lower the blade by turning the actuator screw counter-
clockwise. Always leave the blade in the lowered, ready to cut position.
4. Replace the cutter bezel and secure it with the two screws.
5. Make 3-5 cut cycles to media that is as wide as the maximum media width the printer
supports. This will wipe excess solvent off the baldes.
To Next Page
Loading...