Zebra GC420t User Manual

COBISS System Management Zebra GC420t User Guide
© IZUM, 21. 1. 2014, VIF-NA-26-EN, V1.0 7/23
3 Installing the printer
3.1 Windows environment
To install the GC420t printer in the Windows environment, use the ZDesigner GC420t driver.
NOTE: Do not use the ZDesigner GC420t (EPL) driver.
3.2 VT510 terminal
Use the £ key to get to Set up and then set the printer parameter values with regards to the
output used. The printer can be attached to comm1, comm2 or Parallel:
Set Up Terminal
Printer - Port select -(S1= Comm2 print= Comm1)or
(S1= comm1 print= comm2)or
(S1= commX print= parallel); X=1,2
4 Loading media roll and transfer ribbon
To load media roll and to place ribbon, follow the steps below:
1. Open the printer. Place the media roll as indicated in Figures 10, 11 and 12. Place the
entire roll in the holders and pull the media under the media guides.
Figure 10: Adjusting the media guides when inserting the media roll

Zebra GC420t Specifications

General

Print Method	Thermal Transfer and Direct Thermal
Resolution	203 dpi (8 dots/mm)
Storage Temperature	-40°F to 140°F (-40°C to 60°C)
Max Print Width	4.09 inches
Max Print Speed	4 inches per second
Max Print Length	39 inches
Memory	8 MB SDRAM; 8 MB Flash
Connectivity	USB, Parallel, Serial
Media Width	1.00 inch to 4.25 inches
Media Length	0.38"/9.6 mm to 39"/991 mm
Media Thickness	0.003"/0.08 mm to 0.007"/0.18 mm
Media Type	Roll-fed or fan-fold, die-cut or continuous with or without black mark, tag stock, continuous receipt paper, wristbands
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F/5°C to 105°F/41°C
Humidity	10% to 90% non-condensing
Weight	3 lbs