Zebra GC420t User Guide COBISS System Management
4/23 © IZUM, 21. 1. 2014, VIF-NA-26-EN, V1.0
Figure 5: Opening the printer
Figure 6: Closing the printer with a “snap”
2.2 Connecting to power supply and installing printer
The printer has an inbuilt serial or USB interface.
To connect the GC420t printer to a computer use the USB cable, serial cable or parallel cable
supplied with the printer.
To connect your printer to the mains, use the appropriate power cord and the supplied AC/DC
converter (see Figure 7).
2.2.1 Connecting the printer to power supply
NOTE: Ensure that the appropriate power cord with a three (3) prong plug and an IEC 60320-
C5 connector are used at all times. These power cords must bear the relevant certification mark
of the country in which the product is being used.
To Next Page
Loading...
Need help?
General
