Zebra LI2208 User Manual

STANDARD DEFAULT PARAMETERS A - 3
Caps Lock On Disable 6-7
Convert Wedge Data No Convert 6-8
Caps Lock Override Disable 6-8
Function Key Mapping Disable 6-9
FN1 Substitution Disable 6-9
Send and Make Break Send 6-10
User Preferences
Set Default Parameter Set Factory Defaults 7-4
Report Software Version N/A 7-5
Parameter Bar Code Scanning Enable 7-5
Beep After Good Decode Enable 7-6
Decode Illumination Indicator Disable 7-6
Beeper Tone Medium 7-7
Suppress Power Up Beeps Do Not Suppress 7-9
Beeper Volume High 7-8
Beeper Duration Medium 7-8
Hand-Held Trigger Mode Level 7-9
Hands-Free Mode Enable 7-10
Linear Imager Picklist Mode Auto-discriminate 7-11
Aiming Illumination Pulsing Pattern 7-12
Low Power Mode Enabled 7-12
Time Delay to Low Power Mode 1 Hour 7-14
Time Delay to Presentation Sleep Mode 5 Min 7-15
Continuous Bar Code Read Disable 7-17
Unique Bar Code Reporting Enable 7-17
Decode Session Timeout 9.9 Sec 7-17
Timeout Between Decodes, Same Symbol 0.5 Sec 7-18
Timeout Between Decodes, Different Symbols 0.1 Sec 7-18
Decoding Illumination Enable 7-19
Table A-1 Standard Default Parameters Table (Continued)
Parameter Default
Page
Number
1
User selection is required to configure this interface and this is the most common selection.

Zebra LI2208 Specifications

General

Type	Handheld bar code reader
Wavelength	617 nm
Sensor type	Linear
Scanner type	1D
Read rate (max)	547 reads/s
Pitch reading angle	-65 - 65 °
Motion tolerance (cm/s)	63.5
Linear (1D) barcodes supported	Code 11, Code 128, Code 39, Code 93, EAN-13, EAN-8, GS1 DataBar Expanded, Interleaved 2 of 5, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Not supported
Input voltage	5 V
Power consumption	165 mA
Power source type	DC
Standard interfaces	RS-232
Connectivity technology	Wired
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Certification	EMC FCC Part 15 Class B, ICES 003 Class B, IEC 60601-1-2 Environmental RoHS Directive 2002/95/EEC Electrical Safety C22.2 No. 60950-1, EN 60950-1, IEC 60950-1, UL 60950-1 LED Class 1
Product color	Black
Housing material	-
International Protection (IP) code	IP42
Sustainability certificates	RoHS

Weight and Dimensions

Depth	99 mm
Width	67 mm
Height	160 mm
Weight	140 g