ZPL Configuration
132
The configuration settings listed here resume after the TAKE LABEL sensor value. These listings contain
printer features seldom changed from default or provide status information.
The printer has the ability to set a command or a group of commands once for all receipts (or labels) that
follow. Those settings will remain in effect until they are changed by subsequent commands, the printer is
reset, or you restore factory defaults.
Table 2 ZPL Commands and Configuration Receipt Callout Cross-Reference
Command Listing Name Description
^MP
MODES ENABLED Default: DPCSWFXM (See
^MP
Command)
MODES DISABLED Default: (nothing set)
^JM
RESOLUTION Default: 832 8/mm (203 dpi)
—
FIRMWARE Lists ZPL Firmware Version
—
XML SCHEMA 1.3
—
HARDWARE ID Lists Firmware Boot-block Version
—
CONFIGURATION CUSTOMIZED (after first use)
—
RAM 8176k........ R:
—
ONBOARD FLASH 51200k.........E:
^MU
FORMAT CONVERT NONE
RTC DATE Date Displayed
RTC TIME Time Displayed
NONRESET CNTR0 (1, 2) X,XXX IN
RESET CNTR1 X,XXX IN
RESET CNTR2 X,XXX IN
To Next Page
Loading...