Stereo microscope INTRODUCTION
Stemi 305 General information ZEISS
01/2015 435063-7044-001 7
1 INTRODUCTION
1.1 General information
The stereo microscope Stemi 305 has been designed, produced and tested in compliance with the
standards DIN EN 61010-1 (IEC 61010-1) and IEC 61010-2-101 "Safety Requirements for Electrical
Measuring, Control and Laboratory Equipment".
The device meets the requirements of the EC Directive 98/79/EC Annex 1 regarding ivd products and the
EC RoHS Directive 2011/65/EC and carries the mark.
This operating manual contains information and warnings to be observed by the operator.
The devices must be disposed of in compliance with the WEEE Directive 2012/19/EC.
In this operating manual, the following warning and information symbols are used:
CAUTION
This symbol indicates a possible hazard to the user.
CAUTION
LED risk group 2 acc. to DIN EN 62471:2009 Optical radiation is emitted.
Do not look into the beam. This may damage your eyes.
CAUTION: High-energy UV radiation!
Risk of damage to eyes and skin!
CAUTION
Hot surface!
CAUTION
Remove the power plug before any intervention in the instrument!
ATTENTION
This symbol indicates a possible hazard to the instrument or system.
NOTICE
This symbol indicates information which deserves special attention.
To Next Page
Loading...
