AUX+1, AUX+2, AUX+3
Refer to the brand programming codes on pages 43/44
to find the type and brand name of the device you're
programming.
Press and hold the PRG key until the indicator light
turns on.
Press the AUX key and the 1 on the NUMBER keypad at
the same time (for AUX +1).
Using the NUMBER keypad, enter the three-number code
for the device you've selected.
Press ENTER to save the code.
Turn the device on. Point the remote at the device and
press POWER. It should turn off.
Repeat the steps to program AUX+2, and AUX+3.
1
2
3
4
5
6
7
5
4
3
There are 3 additional Aux modes you can program
6
2
Programming your Zenith remote will allow you to use one
remote to work up to 7 different devices, if all remote operat-
ing modes are programmed!
Not all devices will work with your Zenith remote control.
To Next Page
Loading...
