Preset Faders
The Solution presets have three modes - “Disabled”, “Two Preset” or “Wide”. This can be changed using the PRESET
MODE setting in Special Page 1 of the MFKs.
Preset Faders
The Solution desk has 48 preset faders arranged as two rows of 24 faders and buttons. These control 48 channels
when Preset Mode is “Disabled”, 48 channels when in “Wide ”, or 24 channels in “Two Preset” mode The Solution XL
desk has 96 preset faders arranged as two rows of 48 faders and buttons. These control 96 channels when Preset
Mode is “Disabled”, 96 channels when in “Wide”, or 48 channels in “Two Preset” mode.
Channel Flash Buttons
Each desk has a CHANNEL FLASH button located below each PRESET fader, used to flash, solo or latch the
channels or to select the channels or fixtures assigned to the corresponding faders; their action being determined by
the CHANNEL BUTTON MODE setting in Special Page 1 of the MFKs.
A and B Master Faders
“Disabled” – these faders are unused “Two Preset”– The A MASTER fader controls the maximum output levels from
the PRESET A FADERS. The B MASTER fader controls the maximum output levels from the PRESET B FADERS.
“Wide” – The A MASTER and B MASTER faders control the maximum output levels from all the PRESET faders or the
stored scene according to the setting on the PRESET CONTROL button.
Preset Control Button
The PRESET CONTROL button is only applicable in “Wide” mode and is used to control which of the A or B MASTER
faders has control of the preset faders and which has control over the stored scene. The red LEDs in the button
indicate the current state. Pressing the button swaps the function of the two faders.
Page Controls, Mode Keys and Multi Function Keys (MFKs)
This section of the front panel contains page controls and a seven segment display, a set of Mode keys (FIXTURE,
GROUP, COLOUR, BEAMSHAPE, POSITION, EFFECTS, MACRO, SPECIAL) and a block of 20 Multi Function Keys
(MFKs).
Page Controls and Display
The current Page is indicated on the dual seven segment display. The PAGE UP and PAGE DOWN keys are used to
select the required page. Pressing the PAGE UP and PAGE DOWN keys together selects Page 1. Each mode
(Fixture, Group, Colour etc.) has its own current page.
Mode Keys
The mode keys (FIXTURE, GROUP, COLOUR, BEAMSHAPE, POSITION, EFFECTS, MACRO, SPECIAL) determine
the function of the block of 20 Multi Function Keys (MFKs). Each of the mode keys contains a red LED, which is lit
when selected. If the mode key is flashing, this indicates that the wheels are in control of this attribute but the MFKs
are showing another function. This allows simultaneous selection of fixtures whilst still manipulating attributes, for
example.
Zero 88 - ZerOS - Page 25 of 233 Printed: 23/11/2020 12:50:03 JH
To Next Page
Loading...
Need help?
General
