Shots
This options determines how many times the chase will run after being triggered. When Shots is set to zero, the chase
runs continuously. When Shots is set to a value between 1 and 255, the chase runs the specified number of times and
then stops on the last step. Note – If the Direction modifier is set to Random, then one “shot” is defined as outputting N
steps, where N is the total number of cues in the cue stack.
Sound-to-light
When enabled, each step is triggered by a bass beat on the audio input on the desk rather than the BPM set above. It
is a good idea to send the console a bass filtered signal which has volume control, such as a feed from a sound mixer.
This gives you the greatest control over what will trigger the chase.
Playback Settings
Every playback which has cues recorded, will each have their own
settings available. To open the Playback Settings, hold Setup, and tap
the playback's button. Alternatively, in the Faders window, ensure your
faders are in Playbacks function, and tap on the onscreen fader. By
default, this will open its Settings, however the behaviour of the
onscreen faders in the Faders window can be customised in Setup ->
Settings.
Playback Settings are split into five sections – General , Chase , Raise and Lower , Move On Dark and
Advanced . These are accessed via the five buttons along the top of the window. When you first enter the window,
the “General” tab will be selected unless the playback is set as a chase, in which case the “Chase” tab will be selected
automatically.
Click on the Playback Settings section to learn more...
General
Chase
Advanced
Raise and Lower
Move On Dark
General
The “General” tab is split up into four key parts; Intensity Mixing, Fader
Function, Fader Controls... and Button Function.
Zero 88 - ZerOS - Page 128 of 233 Printed: 23/11/2020 12:50:03 JH
To Next Page
Loading...
Need help?
General
