On FLX, Groups can also be named using syntax by typing one of the following commands:
Group 2 0 7 Name
This displays an onscreen keyboard to name Group 207
Name Group 5 Enter
This displays an onscreen keyboard to name Group 5
Name Group touch an empty group
This displays an onscreen keyboard to name whichever group you touch on the touch screen. You do not need to
press the “group” button if the groups window is already displayed. An onscreen keyboard will then be displayed to
type the group’s name. Press Enter or OK to confirm.
In the same way as when recording, if the Groups window is already displayed on the internal monitor, just tap a group
after pressing the Name button to name that group.
Groups can also be named at the point of recording. For example:
1 Thru 6 Record Group 2 0 Name
1 Thru 6, Record Group 20 Name,
This would record fixtures 1 thru 6 into group 20, and the on-screen keyboard will pop-up for you to use, or use a USB
keyboard to give a name. Press enter to save.
Updating Groups
To update a group, it usually makes sense to recall that group first. To do this, tap the group, or if you wsih to adjust
intensities, double tap the group. Then make a new selection of fixtures, or tweak the intensities, and then press
Update followed by touching the specific group on screen. This updates whichever group you touch on the touch
screen. Updating a group will update the contents of that group but will not alter the name of the group.
Zero 88 - ZerOS - Page 68 of 233 Printed: 23/11/2020 12:50:03 JH
To Next Page
Loading...
Need help?
General
