To do this, CAN must first be enabled within the Trigger tab of Setup.In
the CAN settings of the Triggers tab, virtual Source Controllers canbe
created by pressing “Add”. Each virtual Source Controller requiresa
DMX Start Address and a number of Channels. Only create Source
Controllers you intend to use, as large channel counts can take long
periods of time to be read into iCAN Soft. Behaviour from this point
forward is as per any physical Source Controller on an iCAN network–
scenes can be programmed via iCANsoft and can be triggered via
iCAN messages.
Intensity Mixing
ZerOS fixtures, patch, and other fixture settings are not applied to the Source Controller Emulation. Source Controller
Emulation only has access to direct DMX addresses. When both the Source Controller Emulation and ZerOS Desk
Interface are being used together, operation is completely separate until the DMX is generated. At this point, ZerOS
performs a Highest Takes Precedence (HTP) mix on the outputs. This means that a DMX channel will be outputted at
whichever value is highest between ZerOS Desk Interface and CAN Source Controller Emulation.
Remote Switches
There are 8 close-contact remote switches available. These can be wired in and configured to trigger either a specific
cue or a macro when the circuit is made.
For each switch, choose between Disabled, Go to Cue, or Macro.
For Go to Cue, you can then type x/y, where x is the playback number
and y is the cue number. Cue 0 of a playback can be triggered as a
way to release it.
A 9 pin D-sub connector providing 8 remote switches (common
ground) can be found on the rear of the console. Short pin 1-8 to pin 9
(common) to simulate a button push.
As well as the close contact input on the rear of the console triggering these remote switches, keyboard shortcuts
can too. Ctrl-F1 to Ctrl-F8 will mimic a press of Remote Switch 1 through to 8, giving you 8 keyboard hotkey
functions.
Clear Options
Clear options allows you to clear certain areas of the console, or reset
the console back to factory settings. The Clear Options are split into
Showfile Data, and Desk Settings.
Zero 88 - ZerOS - Page 194 of 233 Printed: 23/11/2020 12:50:03 JH
To Next Page
Loading...
Need help?
General
