11
3. Press the POWER ON / OFF Button four times, this will open up the
Settings menu. Press the SHOOT / RECORD Button to activate the
Settings page.
4. Press the POWER ON / OFF Button three times, this will open up
the ZXM-AC2 hardware Settings menu.
5. Press the DOWN Button twice on the right side of the Unit to
navigate down the menu to ‘Format’.
6. Press the SHOOT/ RECORD Button again to open the Format section.
7. Press the UP / DOWN Button again to select either ‘Confirm’ or
‘Cancel.’ This will initiate the formatting of the Micro SD card.
NOTE: Formatting the Micro SD card will permanently erase any data already
stored on the Micro SD card. Be sure to save your data prior to
Formatting.
6.0 ZXM-AC2 CONTROLS AND FUNCTIONS
6.1 POWER ON / OFF BUTTON
The POWER ON / OFF Button is located on the top left hand corner
of the ZXM-AC2. This is used to power the Unit ON / OFF.
The POWER ON / OFF Button is also used to change between
camera Modes, Settings, and also serves as the back Button when you
are in the navigation Settings.
To Next Page
Loading...
