ZERO-X ZXM-AC2 - Burst Mode

24
7.5 BURST MODE
This function will allow you to take multiple photos in a quick
succession. You can change between: 3 photos/sec, 5 photos/sec, 20
photos/sec and OFF.
The ZXM-AC2 default setting is set to OFF.
To use Burst Mode, you will need to open the Settings menu and
follow the below steps:
1. Press the SHOOT / RECORD Button to end recording if you are in
video mode and recording.
2. Press the POWER ON / OFF Button four times, this will open up the
Settings menu. Press the SHOOT / RECORD Button to activate the
Settings page.
3. Press the POWER ON / OFF Button once, this will open up the
ZXM-AC2 photo Settings menu.
4. Press the DOWN Button three times to navigate down to
Burst
Mode
, you will see this highlighted. Press the SHOOT / RECORD
Button to open up this setting.
5.
Press the UP / DOWN Button to the option you require, you will see
this highlight. To select this option, press the SHOOT / RECORD
Button.
6.
To exit the Settings Menu, press the POWER ON / OFF Button
three times, you will be prompted to press the SHOOT / RECORD
Button to confirm exiting.